Gilderfluke&Co 16 Bit CD-Quality Digital Audio Systems - Manual (Page 25)

- AB-3000, C ARD C AGE AND P OWER S UPPLY C ONNECTIONS -
Each CC-3016 card cage holds sixteen DR-3000s or DR-4000s. The CC-3004 holds up to four DR-
3000s or DR-4000s. All card cage slots on each motherboard will accept any DR-3000. Slot number 0
has an additional 15 position connector that is used by DR-4000s to bring analog and digital inputs to
the card. If required, additional slots can have this connector added. All the connections to the each
DR-3000 are made through the card cagesÕ backplane. Several of these connections are bused be-
tween DR-3000s, while others are brought out to a variety of connectors on the backplane. Each CC-
3004 card cage has the following connections. A CC-3016 has the identical connections, but just more
of them. An AB-3000 AudioBrick has most of these same connections on the outside of its case:
CC-3004 (
OR
CC-3016):
DMX-512 IN
+ gnd -
GILDERFLUKE & COMPANY
CC-3204 CARD CAGE
version 1.1
copyright 1994
DCM
DIGITAL
AUDIO
BUS
RS-422
CARD 3
1/4 J6 IN
SMPTE IN/OUT
STATUS OUT
AES/EBU OUT
SMPTE IN/OUT
STATUS OUT
AES/EBU OUT
SMPTE IN/OUT
STATUS OUT
AES/EBU OUT
SMPTE IN/OUT
STATUS OUT
AES/EBU OUT
CARD
2
CARD
1
CARD
0
1/2 J6/A
VCA INPUTS
AUDIO
OUTPUTS
CARDS 0-3
ALT.
POWER POWER SUPPLY
AUDIO INPUTS AES/EBU INPUTS
1/4
J6 IN
1/4
J6 IN
1/4
J6 IN
a
b
c
d
e f
g
i
h
j
-15 gnd +15 +5
gnd +5
Sense
a) DMX-512: Three position screw terminal block. These signals are bused to any other intercon-
nected card cages through the DIGITAL AUDIO BUS connector (if it is used), so the other bused
cages donÕt need their own DMX-512 connections. This connection is used to feed the USITT
standard DMX-512 serial data into the DR-3000 and DR-4000s mounted in this cage. This can
be used for adjusting volumes and triggering the DR-3000 and DR-4000s.
b) RS-422: Six position RJ-11 (modular telephone style connector jack). These signals are bused
to any other interconnected card cages through the DIGITAL AUDIO BUS connector (if it is
used). The other bused cages then donÕt need their own RS-422 connections. This input is
used to connect the DR-3000 and DR-4000s installed in this cage to a computer or terminal
for configuration or remote control. Facing the end of the cable with the release latch up-
wards, its pin out is as follows:
G ILDERFLUKE & C O . ¥ 205 S OUTH F LOWER S T . ¥ B URBANK , C ALIF . 91502-2102 ¥ 818/840-9484 ¥ FAX 818/840-9485
17 of 92