Gilderfluke&Co 16 Bit CD-Quality Digital Audio Systems User Manual

Page 75

EXAMPLE: to put AB/DR-3000 addressed at 55h into ECHO ALL mode:

e 5 5

EXAMPLE: a 'START CARD# 00' command will echo: t00

¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥

"f"

Exit Echo All Mode:

This command takes all AB/DR-3000s in the system out of ECHO ALL MODE.

EXAMPLE: to take any and all AB/DR-3000s out of ECHO ALL mode:

"g"

Enter Echo Specific Mode:

This command puts all the AB/DR-3000s in the system into ECHO SPECIFIC MODE. When in this

mode, all AB/DR-3000 address-specific commands are echoed by the AB/DR-3000 addressed by the
command. This is the type of echo mode which best verifies the proper operation of all the AB/DR-
3000s.

EXAMPLE: to put AB/DR-3000 addressed at 55h into ECHO mode:

g 5 5

EXAMPLE: a 'START CARD# 00' command will echo: t00

"h"

Exit Echo Specific Mode:

This command takes all AB/DR-3000s in the system out of ECHO SPECIFIC MODE.

EXAMPLE: to take any and all AB/DR-3000s out of ECHO mode:

"i" (CARD#)

Address Status Report:

This command responds with a stream of ASCII HEX data containing the current status of the AB/DR-

3000 specified by the CARD#

EXAMPLE: to poll the status for AB/DR-3000 addressed at 55h:

i 5 5

"l" (CARD#)

Switch Status:

This command responds with the following information for the AB/DR-3000 specified by the CARD#:

EXAMPLE: to poll the input switch status for AB/DR-3000 addressed at 55h:

l 5 5

"m" (5AA5) (CARD#)

Enter Configuration Mode:

This command puts the AB/DR-3000 specified by the CARD# into the configuration mode. All other

AB/DR-3000s in the system are prohibited from receiving any serial commands when there is even one
AB/DR-3000 in setup mode. They will not accept any serial commands until they hear the commands to
exit setup mode being sent to the one AB/DR-3000 which is in this mode. For details on the setup mode,
see the setup section of this manual.

EXAMPLE: to put AB/DR-3000 addressed at 00h into setup mode:

m 5 A A 5 0 0

Note that only one AB/DR-3000 in the entire system is allowed to be in configuration mode at one

time. For this reason, if you try to put a AB/DR-3000 that doesnÕt exist into configuration mode you not
see a configuration screen from that nonexistent AB/DR-3000. All the other AB/DR-3000 in the system
won't listen to you until you take the nonexistent AB/DR-3000 out of configuration mode. To do this, type

ILDERFLUKE

& C

. ¥ 205 S

OUTH

LOWER

. ¥ B

URBANK

, C

ALIF

. 91502-2102 ¥ 818/840-9484 ¥

FAX

818/840-9485

67 of 92