Gilderfluke&Co DMX-512 Input Servo Motor Controller - Manual (Page 25)

n) Test & Adjust Next Output:
l)
Test & Adjust Last Output: These two commands are used to move
the arrow that shows which output you are adjusting. This output will
also be the one sent to the ‘Output Under Test’ LED on the SER-DMX.
x) eXit: This exits the configuration mode and returns the SER-DMX to
the command mode. When exiting you must enter a ‘y’ or ‘n’, to pre-
serve compatibility with some other Gilderfluke & Company cards.
After this card has exited configuration mode, other cards can be
configured.
s) Upload configuration: This command (which doesn't appear on the
menu) is the compliment of the Download Configuration com-
mand. To invoke it, all you need to do is tell your modem program to
send the file saved by the 'download' command back to the SER-
DMX. This will automatically invoke the upload command and store
the incoming data.
+) Data Dump: This command (which doesn't appear on the menu)
dumps out the DMX-512 output buffer and the configuration memo-
ry onto the screen. This started as some developmental routines, and
there was plenty of space available, so what the hell.
G
ILDERFLUKE
& C
O
.• 205 S
OUTH
F
LOWER
S
TREET
• B
URBANK
, C
ALIFORNIA
91502 • 818/840-9484 • 800/776-5972 •
FAX
818/840-9485
E
AST
C
OAST
/F
LORIDA
O
FFICE
• 7041 G
RAND
N
ATIONAL
D
RIVE
• S
UITE
128d • O
RLANDO
, F
L
. 32819 • 407/354-5954 •
FAX
407/354-5955
21 of 22