18 of 22 – Gilderfluke&Co DMX-512 Input Servo Motor Controller User Manual

Page 22

mum position (100%/255/0FFh).

4) Adjust the first endpoint:

a) If you set the movement to the minimum position:

Use the ‘1’, ‘4’ and ‘7’ keys on your keypad to adjust
this endpoint. The movement will follow as you ad-
just these settings.

b) If you set the movement to the maximum position:

Use the ‘2’, ‘5’ and ‘8’ keys on your keypad to adjust
this endpoint. The movement will follow as you ad-
just these settings.

5) Set the output to opposite extreme position:

a) If you have a programming system or Togglodyte

attached: Just set the output to either the mini-
mum position (0%/0/00h) or maximum position
(100%/255/0FFh).

b) If you only have the computer: Use the ‘3’, ‘6’ and

‘9’ keys on your keypad to force the movement to
either the minimum position (0%/0/00h) or maxi-
mum position (100%/255/0FFh).

6) Adjust the second endpoint:

a) If you set the movement to the minimum position:

Use the ‘1’, ‘4’ and ‘7’ keys on your keypad to adjust
this endpoint. The movement will follow as you ad-
just these settings.

b) If you set the movement to the maximum position:

Use the ‘2’, ‘5’ and ‘8’ keys on your keypad to adjust
this endpoint. The movement will follow as you ad-
just these settings.

7) Clear out any forced outputs: If you used the ‘3’, ‘6’ and

‘9’ keys on your keypad to force an output, you will need
to use these keys to ‘un-force’ it as well. If you don’t, the
output will remain ‘stuck’ at this one position. Just hold
down the ‘3’ key until the value reaches the minimum

ILDERFLUKE

& C

.• 205 S

OUTH

LOWER

TREET

• B

URBANK

, C

ALIFORNIA

91502 • 818/840-9484 • 800/776-5972 •

FAX

818/840-9485

AST

OAST

LORIDA

FFICE

• 7041 G

RAND

ATIONAL

RIVE

• S

UITE

128d • O

RLANDO

, F

. 32819 • 407/354-5954 •

FAX

407/354-5955

18 of 22

These are the eight bit resolution values. Substitute the twelve bit equiva-
lents of 100%/4095/FFFh if you are using twelve bit resolutions.