SKC Limited Flite 2 - Manual (Page 22)

Page 20 901-FTM Issue I www.skcltd.com
Operating the Flite 2 Pump
At the end of the first start delay time the pump will
automatically start and the ‘ELAPSED TIME’ screen is
displayed. Again the screen also displays the sample repeat
number and the total number of repeats.
ELAPSED TIME
000:00:23 R00/02
At the end of the first run period the pump will automatically
stop and the ‘TIME TO START’ screen is again displayed.
Note that the sample repeat number has incremented.
TIME TO START
000:29:47 R01/02
At the end of the second delay time the pump will
automatically start and the ‘ELAPSED TIME screen is again
displayed. Note that the elapsed time is the total time for all
run periods.
ELAPSED TIME
001:01:22 R01/02
This cycle will repeat until the end of the final run period. The
pump will automatically stop and the total accumulated run
time is displayed on the LCD screen.
ACCUM RUN TIME
003:00:00 R02/02
5) Manually Stopping the Pump During a Run
Holding a Run - In any operating mode the pump can
be put into ‘Hold’ at any time by pressing the keys in the
sequence
, , . The pump will stop and the
elapsed run time is retained on the LCD screen.
Ж Ж Ж
ELAPSED TIME
000:37:46 HOLD