SKC Limited Flite 2 - Manual (Page 12)

Page 10 901-FTM Issue I www.skcltd.com
Programming the Flite 2 Pump
1) Waking the Pump from Sleep Mode
When not in use the pump should be put into ‘Sleep’ mode
to conserve battery power. The LCD display appears as
shown when in Sleep mode.
SAMPLING PUMP
SLEEPING
To ‘wake’ the pump from Sleep mode press the keypad
keys in the sequence -
, , . The pump will
display the ‘SET UP NOW ?’ screen.
Ж Ж Ж
SET UP NOW ?
YES/no
Alternatively, if a sampling setup has previously been
programmed into the pump, the ‘REVIEW DATA ?’ screen
will be displayed, or if a pump program has been previously
used to take a sample, the ‘USE LAST SETUP ?’ screen is
displayed, when the pump is woken from Sleep mode.
Refer to section - 5) Reviewing Sampling Programs, for
further details.
REVIEW DATA ?
yes/NO
OR USE LAST SETUP ?
YES/no
2) Setting the Flow Rate
Fit a new filter into the sampling head and connect the sampling head outlet to the pump inlet hosetail using
a length of flexible tubing. Connect the sampling head inlet to the outlet of a flow calibration device, such as
a rotameter or Defender primary calibrator.