SKC DataTrac for the Pocket Pump - Manual (Page 13)

11
SKC Pump Scheduler Window
Pump Scheduler Menus
File Menu
Open ......................opens a pump program previously stored to a PC
Save .......................saves a pump program (.pgm) to a PC
Print ........................ prints the pump program schedule displayed on the screen
Exit .........................exits the Pump Scheduler window and returns to the
SKC DataTrac Pump Manager window
View Menu
Pump Sett ings ..............opens the SKC Pump Program Sett ings window
Clock Resolution .........sets the clock resolution
Tools Menu
Clear History ................clears the pump history
Clear Schedule .............clears the programmed pump schedule
Program Edit Bar
The Program Edit Bar (Figure 10) sets a pump program. A program is set by entering the value for each sampling
parameter, including Mode, Rate, Start Date/Time, Stop Date/Time, and Duration, in the cells of the Program Edit Bar.
A pump program contains the following sampling parameters:
Parameter Value
Mode .............Constant Flow or Constant Pressure
Rate ................fl ow rate in mL/min or back pressure in inches of water (H
2
O)
Start Date ......starting date of the program
Start Time .....starting time of the program
Stop Date ......stopping date of the program
Stop Time .....stopping time of the program
Duration .......total run time of the program
To program the above parameters into the cells of the Program Edit Bar, click the various control butt ons
(Figure 9, C through G) that select the value of each parameter, then click the appropriate cell.
Pump Program Scheduler
The Pump Program Scheduler (Figure 11) contains the list of the pump programs (or pump program schedules) set
in the Program Edit Bar. The pump is programmed for a sampling operation by sending this list of programs to the
pump’s memory. The maximum number of programs that can be contained within the list at any given time is 14.
Figure 10. Program Edit Bar
Figure 11. Pump Program Scheduler Containing 1 Program