SecurityMan PIR-SD - Manual (Page 22)

18
Disabling Video Recording
Make sure the host is “DIS-ARMED” and press:
Press and hold down the “Study” button on the back of the PIR-SD
for 5 seconds, then release, and the PIR-SD will beep for 3 seconds
to indicate video recording is successfully disabled.
NOTE: Since the same command are use to remove the remote
control from the PIR-SD and disable the video recording from the
Alarm Host, please pair the remote control back to the PIR-SD
whenever disabling video recording from the Alarm Host.
After the PIR-SD has been successfully added to the Alarm Host
series, the PIR-SD should function in the same manners as the motion
sensor only PIR-SD has the video recording feature. If the PIR-SD is
triggered by motion in Armed mode, it will alarm the Host and at the
same time the Alarm Host will send a signal to the PIR-SD to start
the video recording process. Moreover, if any of the input sensing
device(s) that are pre-programmed to the Alarm Host triggered at
anytime to alarm the host, the PIR-SD will process video recording.
Note: To review the recorded video footages, please follow
“Playback Recorded Video” section above.