SecurityMan PIR-SD User Manual
Page 20
16
video recording (on/off) as shown below. To avoid using multiple remote
controls when integrating the PIR-SD to the Air-Alarm host series, please
add the PIR-SD remote control to the Air-Alarm host series or vice versa.
Adding PIR-SD Remote to the Alarm Host
Step 1: Press
PRGM/SET + Password (system default 888)+ENT+70+
ENT+00+ENT [the “ /Learn” light will appear solid blue/red].
Step2: Press any 1 of the 4 buttons on the PIR-SD remote twice
consecutively to add.
Cancelling PIR-SD Remote from the Alarm Host
Step1: Press
PRGM/SET + Password (system default 888)+ENT+71
+ENT+00+ENT to cancel.
NOTE: Please reference the Air-Alarm series user’s manual as needed
on how to add remote controls. Adding the PIR-SD remote to the
Alarm Host series is not a requirement, only pair them if you want to
use one remote to control both the PIR-SD and the Alarm Host.
Adding PIR-SD Motion Detection to the Alarm Host
Make sure the host is “DIS-ARMED” and press:
Step 1:
PRGM/SET + Password (default is 888) + ENT+ 70 + ENT + XX
+ ENT [Input zones 11~15 for XX indicating the 2nd defense line
dedicated for PIR sensors]
(The “ /Learn” light will appear solid blue/red)
Step 2: Provoke the motion sensor on the PIR-SD 2 consecutive times
to add.
Cancelling PIR-SD Motion Detection from the Alarm Host
Make sure the host is “DIS-ARMED” and press:
PRGM/SET + Password (default is 888) + ENT+ 71 + ENT + XX + ENT
[Input zones 11~15 for XX indicating the zone number that the PIR-SD
were paired to and using code 71 to remove the PIR-SD will remove all