SecurityMan PIR-SD - Manual (Page 21)

17
(up to 4 sensors) sensor that was paired to that zone.]
(The “ /Learn” light will appear solid blue/red)
The alarm host will beep twice, and the “ /Learn” light will flash once
to indicate the PIR-SD motion detection is successfully cancelled from
the Alarm Host.
Enabling Video Recording
To enable video recording, please follow steps 1 and 2 below. Enabling
video recording allows the PIR-SD to start recording video footages
whenever the alarm system are triggered by 24hrs devices, by other
sensors that are pre-paired to the Alarm Host or by the PIR_SD.
Step 1: Press the “Study” button on the back of the PIR-SD
(PIR-SD will beep once).
Step 2: On the Alarm Host Press:
ESC + Password (default is 888) +
ENT + ESC + Password (default is 888) + ENT. The PIR-SD will
beep 5 times indicating the video recording has been
successfully enabled. PIR-SD will beep 2 times to indicate
failure; please repeat steps 1-2 above.
IMPORTANT NOTICE: Enabling video recording when integrating
with SM-8808T or SM-8808E Air-Alarm Hosts will have a 2-sec or
3-sec delay time to record respectively due to processing speed.
Please note that it is normal for the PIR-SD to have a 2~3-sec
delay time to record. It is very important and our recommendation
to mount the PIR-SD 15ft from the intended target for proper
monitoring view and proper recording. Please be sure to thoroughly
test the recording and camera angle before fixing the PIR-SD.
Note: Study mode will automatically turned off if inactive for more
than 20 seconds. During Alarm Host series 40-sec exiting delay
time, the PIR-SD will continue to record if motion is detected.