12 adding and cancelling remote control – SecurityMan PIR-SD User Manual
Page 16
12
Adding and Cancelling Remote Control
Adding Remote Control:
1) While plugged into the power outlet, press and release the
“Study” button located on the back of the PIR-SD. The PIR-SD will
beep once after being pressed indicating that it is in study mode.
2) Press any one of the four buttons on the remote control 2
consecutive times and the PIR-SD will beep 5 times to indicate
the remote control has been successfully added to the PIR-SD.
Note: The PIR-SD will beep twice to indicate failure during the
adding process and exit the study mode if the signal is not received
from the remote control within 20 seconds. Please repeat steps 1-2
above if this should happen.
Cancelling Remote Control:
Press and hold down the “Study” button for 5 seconds and then
release, the PIR-SD will beep for 3 seconds to indicate the remote
control is sucessfully cancelled from the PIR-SD.