Salamander Designs Synergy System SNX20C/B - Manual (Page 2)

Salamander Designs Ltd. 800-535-5659 • www.SalamanderDesigns.com
Doc No. 500-360/v2 ©2002 Salamander Designs Ltd.
Limited Warranty
For five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other
equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in a
shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.
1
Remove Top Bolts
Remove the four connector bolts securing
the top shelf. Save for Step 6.
2
Attach Extension Post
A. Screw threaded studs into the ends
of the posts. Tighten with hex key.
Stick felt pads to underside of post,
this will prevent marring the surface
of the top shelf.
B. Screw the posts into the base unit.
Be sure to square the post with the
shelf. Do not over tighten.