Salamander Designs Synergy System SB229C/B - Manual

TM
SYNERGY 229
Twin Assembly
Includes:
(1) Twin 20 Unit
(2) S20 Side Panels
(2) S10 Doors
(1) Double-Width Shelf
Salamander Designs Ltd. • 800-535-5659 • www.SalamanderDesigns.com ©2008 Salamander Designs Ltd. Synergy System, Patented.
Limited Warranty
Five full years Salamander Designs Ltd will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other
equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the original carton and packing material. Any damage incurred in
a shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.
Doc No. 500-615/v8.12 229 -1/4
BEFORE YOU BEGIN:
• Unpack all parts and read instructions carefully before beginning.
• Shelf pegs and door hinges must slide into the channels of the post in the correct order.
They cannot be removed individually without disassembling the whole unit.
1
90 O
B
.
Connect Post
Screw foot with metal washer through bottom
shelf and into the end of each extruded post.
Hand tighten fully and use wrench to tighten
nut onto underside of shelf.
A
.
Square Post
Square the post to the bottom shelf.
Connect Posts to Bottom Shelf
! !
Short Post
WARNING: Tighten by screwing the leveler foot NOT the post.
Leveler Foot
Hex Nut
Washer