Salamander Designs Synergy System SB248C/B - Manual (Page 2)

1
2
2
1
1
Leveler Foot
Hex Nut
Washer
90 O
B
.
Connect Post
Screw foot with metal washer through bottom
shelf and onto the end of each extruded post.
Hand tighten fully and use wrench to tighten
nut onto underside of shelf.
Note:
“BOTTOM SIDE FRONT”
Label position down. and
towards front - Both Panels
A
.
Square Post
Square the post to the bottom shelf.
Connect Posts to Bottom Shelf
WARNING: Tighten by screwing the leveler foot NOT the post.
2 Add Shelf Pegs & Door Hinges
! !
B
.
Heavy Duty Bracket
The heavy duty brackets will be used
to support the double-width shelf.
C
.
Door Hinges & Shelf Pegs
1. Slide the bottom hinge plate through
the front post channels. (Doors can be either
left or right side opening.)
2. Insert one shelf peg into each post
location shown.
3.
4.
Slide top hinge plate through front
Use spacer tool as in step 5 to align
brackets and pegs.
post channels.
A
.
Group Shelf Pegs
There are two varieties of shelf pegs (A and B).
They are designed to cradle the shelf in place.
Refer to drawing.
1 2
2
2
1
1
Doc No. 500-255 v 7/11 2 of 4
!