Salamander Designs Synergy System SB323C/B - Manual (Page 4)

A
.
Insert Hardware
Combine the 1” threaded studs with the flat
nuts. Slide hardware into rear channel.
C
.
Secure Studs
Use the hex key to secure the all
studs to the posts.
B
.
Place Panel
Allow bottom studs to remain
loose at bottom of post. Align the
Spacer Tool at the top of the post,
then position top studs through the
small “Rear Panel” hole. Repeat this
step with the bottom studs aligning
the Tool along the bottom of post to
set spacing for cable passage.
1
2
3
4
5
6
7
8
9
S2 0 / SV DO REA R P ANE L
41/ 2 "
6"
8"
www
.salamanderdesigns.com E XTE NDE D REA R P ANE L
S 30 / S 40 REA R P ANE L
SP ACER TOOL
1
2
3
4
5
6
7
8
9
S20 / SVDO REAR PANEL
41/2"
6"
8"
www .salamanderdesigns.com EXTENDED REAR PANEL
S30 / S40 REAR PANEL
SP ACER TOOL
2X 2X
2X
REAR
Attach Rear Panel
C
.
Insert Side Panels
Carefully slide side panels down center
channel of outside post. Be sure the
posts are square to the bottom shelf to
prevent any damage to side panels.
D
.
Secure Rear & Top
Put the remaining thumb nuts on
to complete panel installation.
B
.
Fine Tuning
Use the bubble level to precisely adjust
the shelves. Be sure to level both sides
as well as front to back. Use the hex
key to tighten each peg.
A
.
Placing & Adjusting Shelves
Place shelves from the bottom up. Angle the
shelf in between the front post and set on top
of shelf pegs. Use the Spacer Tool to adjust
spacing between shelves. Position the peg
through the Spacer and tighten.
5
Final Assembly
4
Doc No. 500-750/v2.12 323 -4/4
A B
SOFT CLOSE INSTALLATION
SLOW CLOSE
FAST CLOSE