Salamander Designs Synergy System SB323C/B - Manual (Page 2)

! !
A B
1
Leveler Foot
Hex Nut
Washer
90 O
B
.
Connect Post
Screw foot with metal washer
through bottom shelf and onto
the end of an extruded post. Hand
tighten fully and use wrench on
hex nut to tighten nut onto
underside of shelf.
A
.
Square Post
Square the post to the bottom shelf.
Connect Posts to Bottom Shelf
WARNING: Tighten by screwing the leveler foot NOT the post.
2
Add Shelf Pegs & Door Hinges
B
B
A
A
B
.
Insert Hinges & Add Shelf Pegs
Note: The doors can be either left or right side opening. Select a side to open each door.
1. Hold door above the post and slide the bottom
hinge plate through the post channel.
2. Insert two shelf pegs.
3. Slide top hinge plate through.
4. Repeat Steps 1-3 on second door.
5. Gently tighten all remaining pegs with the
hex key to desired position.
A
.
Group Shelf Pegs
There are two varieties of shelf pegs (A and B).
They are designed to cradle the shelf in place.
Refer to drawing.
Doc No. 500-750/v2.12 323 -2/4