Miscellaneous functions, Initializing the midiverb iii – ALESIS MIXING CONSOLES User Manual

Page 59

SECTION 4

MISCELLANEOUS FUNCTIONS

INITIALIZING THE MIDIVERB III

There are two reasons why you may want to reinitialize your
MIDIVERB III :

1) To return all programs to their factory parameter settings (called
"initializing").

2) In case the unit locks up from a power surge.

To initialize your MIDIVERB III, do the following:

1) Turn the MIDIVERB III off.

2) Hold the

INT. PROG

and

STORE

buttons.

3) Turn the MIDIVERB III on again while holding the above
buttons.

---

PLEASE NOTE:

—

This procedure will erase all user stored parameters and return all

MIDIVERB III parameters to their default values.

—

The MIDI program table will return to 000 through 199.

—

Programs 100 through 199 will become duplicates of factory

programs 000 through 099.

—

The display will be blank for about ten seconds while the memory is

initialized.

CAUTION: This procedure will erase all user programs from memory!!