Robertshaw 8625-1 - Manual (Page 8)

Programming Guide
SETTING TIME OF DAY AND
DAY OF WEEK
1. Press SELECT until the cursor is
over . Press SET. The HOURS
segment will be blinking. Use the
or button to adjust the
HOURS setting. NOTE: The
AM or PM indicator will change
as the HOURS display rolls
through a 24 hour cycle.
2. Press SET. The MINUTES segment will be blinking. Use the or
button to adjust the MINUTES setting.
3. Press SET. The DAY segment will be blinking at the top of the
display. Use the or button to adjust the day of the week.
Press SET.
PROGRAMMING YOUR THERMOSTAT
The 8625 thermostat features 1-button programming. Simply follow these
steps to customize your thermostat for your lifestyle.
1. Place the HEAT-OFF-COOL switch into the HEAT position. Make sure
the cursor is in the PROG position. Press SET. The HOURS segment
will be blinking. MON thru FRI (the work
week) will be displayed across the top.
AM1 will be illuminated in the lower right
hand corner. You can now start program-
ming the first event of the work week.
2. Use the or button to adjust the hour
of the first event. Press SET.
3. The MINUTES segment will be blinking. Use the or button to
adjust the minutes. Press SET.
4. The temperature should be blinking. Use the or button to
adjust the desired temperature of the first event. Press SET.
5. AM2 should now be displayed. Repeat steps 2-4 to program the
remaining events (PM1 and PM2) for the
work week. There are a total of 4 events.
8
MON = MONDAY
TUE = TUESDAY
WED = WEDNESDAY
THU = THURSDAY
FRI
= FRIDAY
SAT = SATURDAY
SUN = SUNDAY
select set
hold
vac prog temp
MON
° F
on auto cool off emer heat
select set
hold
vac prog temp
on
Cursor
110-1166 6/8/05 9:15 AM Page 8