Ransburg M90 Handguns 77073, 77132 - Manual (Page 6)

AH-99-01.3
M90 Handguns - Safety
2 2 2 2 2
A R E A A R E A A R E A A R E A A R E A
Tells where
hazards may occur.
H A Z A R D H A Z A R D H A Z A R D H A Z A R D H A Z A R D
Tells what the hazard is.
SAFEGUARDS SAFEGUARDS SAFEGUARDS SAFEGUARDS SAFEGUARDS
Tells how to avoid the hazard.
Spray Area Spray Area Spray Area Spray Area Spray Area Fire Hazard
Improper or inadequate opera-
tion and maintenance procedures
will cause a fire hazard.
Protection against inadvertent
arcing that is capable of causing
fire or explosion is lost if any
safety interlocks are disabled
during operation. Frequent
power supply shutdown indicates
a problem in the system requir-
ing correction.
Fire extinguishing equipment must be present in
the spray area and tested periodically.
Spray areas must be kept clean to prevent the ac-
cumulation of combustible residues.
Smoking must never be allowed in the spray area.
The high voltage supplied to the atomizer must be
turned off prior to cleaning, flushing or maintenance.
When using solvents for cleaning:
Those used for equipment flushing should have
flash points equal to or higher than those of the
coating material.
Those used for general cleaning must have flash
points above 100
o F (37.8 o C).
Spray booth ventilation must be kept at the rates
required by NFPA 33, OSHA and local codes. In
addition, ventilation must be maintained during
cleaning operations using flammable or combus-
tible solvents.
Electrostatic arcing must be prevented.
Test only in areas free of combustible material.
Testing may require high voltage to be on, but only
as instructed.
Non-factory replacement parts or unauthorized
equipment modifications may cause fire or injury.
If used, the key switch bypass is intended for use
only during setup operations. Production should
never be done with safety interlocks disabled.
The paint process and equipment should be set up
and operated in accordance with NFPA 33, NEC, and
OSHA requirements.
Toxic Substances Toxic Substances Toxic Substances Toxic Substances Toxic Substances Certain material may be harmful
if inhaled, or if there is contact
with the skin. Follow the requirements of the Material Safety Data
Sheet supplied by coating material manufacturer.
Adequate exhaust must be provided to keep the air
free of accumulations of toxic materials.
Use a mask or respirator whenever there is a
chance of inhaling sprayed materials. The mask
must be compatible with the material being sprayed
and its concentration. Equipment must be as pre-
scribed by an industrial hygienist or safety expert,
and be NIOSH approved.
ARCHIVE