Ransburg M90 Handguns 77073, 77132 - Manual (Page 34)

AH-99-01.3
M90 Handguns - Maintenance
3 0 3 0 3 0 3 0 3 0
3. Connect and secure the low or high volt-
age cable assembly to the handle of the
gun.
4. Turn the power, air, and fluid ON at the
source and return the gun to service.
4. Screw the filter retaining nut onto the
swivel fitting and tighten using a 3/4-inch
open end wrench.
5. Tighten the set screw using a 3/32-inch
Allen wrench.
Fluid Line Removal Fluid Line Removal Fluid Line Removal Fluid Line Removal Fluid Line Removal
1. Disconnect the whip hose from the
swivel fitting.
2. Disconnect the fluid hose from the paint
supply.
Fluid Line Installation Fluid Line Installation Fluid Line Installation Fluid Line Installation Fluid Line Installation
1. Connect the fluid hose to the paint sup-
ply.
2. Connect the whip hose to the swivel fit-
ting.
Air Line Removal Air Line Removal Air Line Removal Air Line Removal Air Line Removal
1. Disconnect the air hose assembly from
the air fitting using appropriate
wrenches.
2. Disconnect the air hose assembly from
the factory air line regulator.
Air Line Installation Air Line Installation Air Line Installation Air Line Installation Air Line Installation
1. Connect the air hose assembly to the
factory air line regulator.
2. Connect the air hose assembly to the air
fitting using appropriate wrenches.
T T T T To Return the Gun to the o Return the Gun to the o Return the Gun to the o Return the Gun to the o Return the Gun to the
Work Site Work Site Work Site Work Site Work Site
1. Attach the air hose assembly to gun air
inlet fitting.
2. Attach the whip hose to the swivel fitting.
ARCHIVE