Ransburg EFM & EFMD Solvent Applicator 76480, 76482, 76485, 76488 - Manual (Page 32)

AA-99-01.1 2 7 2 7 2 7 2 7 2 7
EFM(D) Solventborne Robotic Atomizers - Maintenance
Figure 7: Applicator Removal from Robot Manifold Figure 7: Applicator Removal from Robot Manifold Figure 7: Applicator Removal from Robot Manifold Figure 7: Applicator Removal from Robot Manifold Figure 7: Applicator Removal from Robot Manifold
1 76479-00 Spray Head Assembly, Resistive, EFM 1
2 76481-00 Applicator Housing Assembly, Single, 60 Degree 1
3 EMF0600-02 Shroud, ITW Logo, EFM 1
4 7554-08 O-Ring, #2-011, Fluorocarbon, Viton 4
5 SSF-3125 Screw, SHCS, 5/16-18 x .75" Long, Nylon 4
6 EMF-97 Locating Pin 3
7 EMF-204 Socket Head Cap Screw, Captive 6
8 76554-00 Flange, Mounting Ring 1
Item # Item # Item # Item # Item #
76480 EFM APPLICA 76480 EFM APPLICA 76480 EFM APPLICA 76480 EFM APPLICA 76480 EFM APPLICAT T T T TOR ASSEMBL OR ASSEMBL OR ASSEMBL OR ASSEMBL OR ASSEMBLY Y Y Y Y - P - P - P - P - PAR AR AR AR ARTS LIST TS LIST TS LIST TS LIST TS LIST (Figure 7) (Figure 7) (Figure 7) (Figure 7) (Figure 7)
Part # Part # Part # Part # Part # Description Description Description Description Description Qty Qty Qty Qty Qty
REMOVING APPLICA REMOVING APPLICA REMOVING APPLICA REMOVING APPLICA REMOVING APPLICAT T T T TOR OR OR OR OR
FROM THE ROBOT FROM THE ROBOT FROM THE ROBOT FROM THE ROBOT FROM THE ROBOT
MANIFOLD ASSEMBL MANIFOLD ASSEMBL MANIFOLD ASSEMBL MANIFOLD ASSEMBL MANIFOLD ASSEMBLY Y Y Y Y
(See Figure 7) (See Figure 7) (See Figure 7) (See Figure 7) (See Figure 7)
Any time service is required within the applicator
shroud, the applicator must be removed from the
robot manifold assembly. After the applicator is
removed from the robot manifold, always move to
a clear, clean work area to remove the applicator
shroud and begin servicing.
1. Purge all fluid from the system and blow lines
dry with pushout air before the applicator is re-
moved.
2. All pressures must be removed, both air and
fluid, before removing the applicator. Fluid pressure
can be removed by actuating the applicator trigger
with the paint regulator open.
3. Remove the applicator from the robot manifold
assembly by unscrewing six socket head cap
screws [7]. The screws are retained in the mounting
flange and only need to be unscrewed far enough
to release the threads from the robot manifold.
> Eye protection should be worn while servic-
ing applicator.
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G
!!!!!