Ransburg EFM & EFMD Solvent Applicator 76480, 76482, 76485, 76488 - Manual (Page 14)

AA-99-01.1
INST INST INST INST INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
9 9 9 9 9
EFM(D) Solventborne Robotic Atomizers - Installation
EFM AND EFMD EFM AND EFMD EFM AND EFMD EFM AND EFMD EFM AND EFMD
ROBOTIC A ROBOTIC A ROBOTIC A ROBOTIC A ROBOTIC AT T T T TOMIZER OMIZER OMIZER OMIZER OMIZER
INST INST INST INST INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
This information is intended ONLY ONLY ONLY ONLY ONLY to indicate the
general installation parameters of this product
and, where applicable, its working relationship to
other ITW Ransburg system components in typical
use. Each installation is unique and should be
directed by an authorized ITW Ransburg
representative or conducted from the ITW
Ransburg installation drawings provided for your
particular installation.
POWER SUPPL POWER SUPPL POWER SUPPL POWER SUPPL POWER SUPPLY Y Y Y Y
ASSEMBL ASSEMBL ASSEMBL ASSEMBL ASSEMBLY Y Y Y Y
Refer to the ITW Ransburg Service Manual
MicroPak Control Unit
MicroPak Control Unit MicroPak Control Unit MicroPak Control Unit MicroPak Control Unit, for complete information
regarding power supply installation.
Two low voltage control cables, 76495 and 76496,
connect from the Output terminal connection
(J3), located on the back of the power supply
assembly. These cables connect from the terminal
block (J3) to the robot manifold plate.
N O T E S N O T E S N O T E S N O T E S N O T E S
> The power supply MUST MUST MUST MUST MUST be located
outside the HAZARDOUS HAZARDOUS HAZARDOUS HAZARDOUS HAZARDOUS area (Reference
OSHA and NFPA-33).
> User should be aware of, and adhere to,
all local fire codes and ordinances.
> The user MUST MUST MUST MUST MUST provide a properly fused
disconnect between the power source and the
power supply which complies with appropri-
ate codes.
W A R N I N G W A R N I N G W A R N I N G W A R N I N G W A R N I N G !!!!!