Ransburg Aerobell M Rotary Atomizer 78101 - Manual (Page 23)

LN-9237-00.1
Aerobell M Rotary Atomizer - Operation
19 19 19 19 19
ELECTROST ELECTROST ELECTROST ELECTROST ELECTROSTA A A A ATIC TIC TIC TIC TIC
VOL VOL VOL VOL VOLT T T T TAGE AGE AGE AGE AGE
The Aerobell M Rotary Atomizer receives its op-
erating voltage through a high voltage cable that
is connected to a remote power supply. The
power supply model and high voltage setting will
depend upon various application requirements.
See the "Specifications" section of this manual
for approved power supplies and refer to that
manual for detailed operating instructions.
NOTES: NOTES: NOTES: NOTES: NOTES:
> If paint defects occur, such as fatty
edges or picture framing, reducing the
voltage should be a last
last last last last resort. To
correct the problem, adjustments to paint
resistivity or lead and lag trigger adjust-
ments should be made.
The electrostatic voltage applied to the
Aerobell M will affect pattern size, transfer
efficiency, wrap and penetration into cav-
ity areas. Normally 100 kV setting is ap-
propriate for most applications.
T T T T TARGET ARGET ARGET ARGET ARGET DIST DIST DIST DIST DISTANCE ANCE ANCE ANCE ANCE
The distance between the Aerobell M atomizer
and the target will affect the finish quality and
efficiency. Closer distances give a smaller pat-
tern, wetter finish and greater efficiency.
Greater distance will provide a larger pattern
size and drier finish. The high voltage circuitry
will enable the applicator bell to be operated to
within a few inches of the target without adjust-
ing the voltage setting. The recommended tar-
get distance is 10 to 14 inches.
NOTE NOTE NOTE NOTE NOTE