Ransburg Aerobell M Rotary Atomizer 78101 - Manual (Page 15)

LN-9237-00.1
AIR FIL AIR FIL AIR FIL AIR FIL AIR FILTRA TRA TRA TRA TRATION TION TION TION TION
REQUIREMENTS REQUIREMENTS REQUIREMENTS REQUIREMENTS REQUIREMENTS
> Air must be properly filtered to ensure
extended turbine life and to prevent
contamination of the paint finish. Air
which is not adequately filtered will foul
the turbine air bearings and cause turbine
failure. The correct type of filters must be
used in an Aerobell M system. The filter
elements must be replaced on a regular
schedule to assure clean air.
> It is the user’s responsibility to en- It is the user’s responsibility to en- It is the user’s responsibility to en- It is the user’s responsibility to en- It is the user’s responsibility to en-
sure clean air at all times. Turbine failure sure clean air at all times. Turbine failure sure clean air at all times. Turbine failure sure clean air at all times. Turbine failure sure clean air at all times. Turbine failure
resulting from contaminated air will not
resulting from contaminated air will not resulting from contaminated air will not resulting from contaminated air will not resulting from contaminated air will not
be covered under warranty.
be covered under warranty. be covered under warranty. be covered under warranty. be covered under warranty. Figure 8
shows the pre-filter and bearing air filter(s)
which are recommended for use in
Aerobell M systems. If other filters are
incorporated in the system, the filters to
be used must have filtering capacities
equal or better than those shown in Figure
8.
> The user must ensure the bearing air
supply is not inadvertently turned off while
the Aerobell M air motor is turning. This
will cause air bearing failure.
Aerobell M Rotary Atomizer - Installation
ITW Ransburg ITW Ransburg ITW Ransburg ITW Ransburg ITW Ransburg
Filter Model No.
Filter Model No. Filter Model No. Filter Model No. Filter Model No.
HAF-503
RPM-417
RPM-418
HAF-15 Element, One
RPM-32 Elements,
Carton of 4
RPM-33 Elements,
Carton of 8
Pre-filter, removes coarse amounts of oil, moisture &
dirt. Used upstream of RPM-417 pre-filter (used in
systems with poor air quality).
Pre-filter, coalescing type, 136 scfm, 98.5% efficiency
particulate removal .3 to .6 micron, max. aerosol passed
1.0 micron, max. solid passed .4 micron (dependent
upon scfm requirement per applicator, one RPM-417
can be used with up to three Aerobell M assemblies).
Bearing air filter, coalescing type, 19 scfm, 99.995%
efficiency particulate removal .3 to .6 micron, max.
aerosol passed .6 micron, max. solid passed .2 micron
(one per applicator).
Description / Specifications Description / Specifications Description / Specifications Description / Specifications Description / Specifications
Replacement Replacement Replacement Replacement Replacement
Element Part No.
Element Part No. Element Part No. Element Part No. Element Part No.
Figure 8: Recommended Air Filtration Figure 8: Recommended Air Filtration Figure 8: Recommended Air Filtration Figure 8: Recommended Air Filtration Figure 8: Recommended Air Filtration
C A U T I O N C A U T I O N C A U T I O N C A U T I O N C A U T I O N !!!!!
11 11 11 11 11