Ransburg Aerobell M Rotary Atomizer 78101 - Manual (Page 14)

LN-9237-00.1
Aerobell M Rotary Atomizer - Installation
INST INST INST INST INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
AIR FIL AIR FIL AIR FIL AIR FIL AIR FILTER INST TER INST TER INST TER INST TER INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
The following air filter installation guidelines are
essential for optimum performance.
1. Use only recommended pre-filters and
bearing air filters as shown in Figure 8.
Additional system air filtration (i.e., refrig-
erated air dryer) may also be used if de-
sired.
2. Mount the bearing air filter as close as
possible to the Aerobell M. (Do not
mount further than 30 feet away.)
3. Do not use Teflon tape, pipe dope, or
other thread sealant downstream of the
bearing air filter. Loose flakes of teflon
tape or other sealant can break loose
and plug the very fine air holes in the
turbine air bearings.
4. If air heaters are used in the system (to
minimize the effect of excessively humid
conditions), and the heated air will ex-
ceed 120
o F, the heaters must be located
after all filters to prevent damage to the
filter media.
10 10 10 10 10
AIR PRESSURE AIR PRESSURE AIR PRESSURE AIR PRESSURE AIR PRESSURE
REQUIREMENTS REQUIREMENTS REQUIREMENTS REQUIREMENTS REQUIREMENTS
1/4" O.D.
1/4" O.D.
1/2" O.D.
3/8" O.D.
3/8" O.D.
1/4" O.D.
1/4" O.D.
1/4" O.D.
Bearing Air
Supply (B.A)
Bearing Air
Return (B.A)
Turbine Air (T.A)
Shaping Air (S.A)
Brake Air (BRK)
(if used)
Trigger Valve
Control (TV)
Dump Valve
Control (DV)
Solvent Valve
Control (SV)
90 psi ±10
(621kPa ± 69kPa)
80 psi ±10
(551kPa ± 69kPa)
Variable
Variable
60 psi ±10
(413kPa ± 69kPa)
80 psi ±10
(551kPa ± 69kPa)
80 psi ±10
(551kPa ± 69kPa)
80 psi ±10
(551kPa ± 69kPa)
Figure 7: Air Tubing Connections Figure 7: Air Tubing Connections Figure 7: Air Tubing Connections Figure 7: Air Tubing Connections Figure 7: Air Tubing Connections
Tube Size Tube Size Tube Size Tube Size Tube Size
Air Pressure Air Pressure Air Pressure Air Pressure Air Pressure
Requirements Requirements Requirements Requirements Requirements
Paint Fluid Regulator (Optional): Paint Fluid Regulator (Optional): Paint Fluid Regulator (Optional): Paint Fluid Regulator (Optional): Paint Fluid Regulator (Optional):
High Flow
Signal Air (High)
Low Flow
Signal Air (Low)
1/4" O.D.
1/4" O.D.
Variable
70 psi max.
(482 kPa)
Variable
80 psi max.
(551 kPa)