Archive – Ransburg REM Automatic Applicator 73499 User Manual

Page 33

AA-87-02.3

2 8

REM Automatic Applicator - Maintenance

4. Place the piston assembly [30] through [34] into
the valve chamber through bushing [28] and press
into place.

Be sure that o-ring [29] is in bushing

[28].

N O T E

5. Replace the barrel/cascade assembly (see
“Barrel/Cascade Assembly” in this section).

6. Replace the transformer assembly (see
“Transformer Assembly” in this section).

7. Place nut [34] on rod extension [22] 1/16-inch
from piston shaft [30].

8. Place nut [36] on rod extension [22] and secure
against nut [35] using appropriate wrenches. Be
sure to maintain the 1/16-inch spacing between
nut [35] and piston shaft [30].

9. Place springs [37] and [38] against piston [33]
and nut [36] and secure in place by screwing
piston housing [39] into the rear of the valve
housing.

Fluid T

Fluid Tube Removal

ube Removal

1. Remove fluid line and fluid filter [74] from fitting
[70].

2. Remove nut [71] from fitting [70].

3. Remove screw [56] from support bracket [52]
and [56] using 2.5mm Allen wrench.

4. Lossen nut [67] with an adjustable wrench. Grip
elbow connection [68] and pull straight down to
remove connector [67] from barrel [18] at [101].

5. Remove bracket [55] and [70] from fluid tube
[69].

6. Remove fluid tube [89] from elbow connector
[88].

7. Using fluid fitting tool [75], place over fluid
connector [85] and remove from elbow connection
[66]. Nut [67] will come off when fluid connector
[65] is removed from elbow connection [68].

Removing the connector [67] other than

straight down from barrel [18] may damage
or breach the connector [67]

C A U T I O N

!!!!!

This step may be eliminated if the Fluid

Connector [65] is NOT

NOT

NOT damaged.

N O T E

8. Replace o-rings [66], gasket [64] on any worn
or broken parts if required.

ARCHIVE