Ransburg REM Automatic Applicator 73499 - Manual (Page 30)

AA-87-02.3 2 5 2 5 2 5 2 5 2 5
REM Automatic Applicator - Maintenance
2. Remove the barrel cascade assembly. (See
“Barrel/Cascade Assembly Replacement” in this
section.)
3. Remove gasket [21].
4. Slide transformer [44] toward and out of
channel [106].
5. Slide replacement transformer [44] into channel
[106].
6. Place gasket [21] in position.
7. Install the barrel/cascade assembly. (See
“Barrel Assembly” in this section.)
8. Install low voltage cable. (See “Low Voltage
Cable Replacement” in this section.)
Body Assembly Service Body Assembly Service Body Assembly Service Body Assembly Service Body Assembly Service
When service is performed on any of the handle
elements, it is best to remove the barrel/cascade
and hook/transformer assemblies, (see “Trans-
former/Assembly Replacement” in this section)
in order to avoid damage to the nozzle, needle/
electrode or any of the plastic parts. After
disassembly of any handle element:
• Clean all parts with a suitable, clean solvent.
• Check all parts for damage or wear. Replace
those that are damaged or worn with new parts.
• Replace and lubricate all seals and o-rings.
> Transformer assemblies manufac-
tured in late 1986 or later have a screwed
in removable glass lense. The lense has
pin holes for an adjustable spanner wrench
with 18mm (.126-inch) pins. Earlier mod-
els have a glass lense epoxied in place
which can also be replaced.
N O T E N O T E N O T E N O T E N O T E
Assist Air V Assist Air V Assist Air V Assist Air V Assist Air Valve alve alve alve alve
Disassembly: Disassembly: Disassembly: Disassembly: Disassembly:
1. Turn adjustment knob [58] to the open position
(fully extended), to accommodate Step 2.
2. With a 9/16” wrench, unscrew valve housing
[59] and remove the entire assembly from chamber
[107].
3. Return the control knob to the closed position.
4. Secure adjustment knob [58] in a bench vise
and, with a 1/4” wrench on wrench flats [108], free
needle [63] and remove it from the assembly.
> The needle/control knob is secured
with Lock-Tite.
N O T E N O T E N O T E N O T E N O T E
5. Remove spring [62].
6. Unscrew adjustment knob [59] from housing
[59].
7. With a 1/4-inch rod or other small diameter tool,
force washers [61] and o-ring [60] out of the
housing [59].
Assist Air V Assist Air V Assist Air V Assist Air V Assist Air Valve alve alve alve alve
Assembly: Assembly: Assembly: Assembly: Assembly:
1. Screw adjustment knob [58] completely into
housing [59].
> Apply a light coating of dielectric grease
to the control knob threads [109].
N O T E N O T E N O T E N O T E N O T E
ARCHIVE