beautypg.com

Archive – Ransburg REM Automatic Applicator 73499 User Manual

Page 31

background image

AA-87-02.3

2 6

2 6

2 6

2 6

2 6

REM Automatic Applicator - Maintenance

2. Place one (1) washer [61], o-ring [60], and the
other washer [61] onto the shaft of adjustment
knob [58].

3. Use the flat end of the tubular spanner tool to
seat [61], [60], and [61] in the bore of the housing
[59].

4. Place spring [62] onto the shaft of adjustment
knob [58].

5. Secure adjustment knob [58] in the bench vise
and put a small amount of 7969-00 medium
strength sealant on the shaft threads [114].

6. With a 1/4” wrench on wrench flats [108], screw
needle [63] onto the control knob shaft. Remove
the assembly from the vise.

7. Unscrew adjustment knob [58] to its open
position.

8. Screw housing [59] into valve chamber [107]
with a 9/16” wrench.

>

Apply a light coating of dielectric

grease to the housing threads.

N O T E

N O T E

N O T E

N O T E

N O T E

9. Screw the adjustment knob down to the closed
position.

Low V

Low V

Low V

Low V

Low Voltage Cable Replacement

oltage Cable Replacement

oltage Cable Replacement

oltage Cable Replacement

oltage Cable Replacement

Disassembly:

Disassembly:

Disassembly:

Disassembly:

Disassembly:

1. Follow the procedures in “To Remove the
Applicator from the Work Site” in this section.

2. Loosen (but do NOT remove) set screw [72]
with a 3/32” Allen wrench.

3. Pull low voltage cable [43] STRAIGHT OUT

STRAIGHT OUT

STRAIGHT OUT

STRAIGHT OUT

STRAIGHT OUT

OF CHAMBER

OF CHAMBER

OF CHAMBER

OF CHAMBER

OF CHAMBER [118].

Assembly:

Assembly:

Assembly:

Assembly:

Assembly:

1. Start low voltage cable [43] into chamber [118]
so the set screw indent is to the front of the
applicator.

2. Secure the low voltage cable [43] with front set
screw [72] using a 3/32” Allen wrench.

>

This step secures the grounding

bracket, air and fluid lines, and the cable
to the applicator handles.

N O T E

N O T E

N O T E

N O T E

N O T E

>

When removing or installing the low volt-

age cable, DO

DO

DO

DO

DO NOT

NOT

NOT

NOT

NOT rotate the assembly.

This can cause damage to the contact pins
or to the bottom of the transformer/hook
assembly.

C A U T I O N

C A U T I O N

C A U T I O N

C A U T I O N

C A U T I O N

!!!!!

ARCHIVE