Hauler Racks UTRAHDMINI-1 - Manual (Page 7)

7 of 8
Toll Free: 1-800-843-5445
Phone: 763-546-5620
Fax: 763-546-0933
HAULER RACKS, INC.
7109 31
st Avenue North
Minneapolis, MN 55427-2848
WWW.HAULERRACKS.COM
7. Mounting to truck bed
Place the rack assemblies on the truck in the desired positions.
Adjust the lip mounts so that it rests on the lip of the truck bed. Make sure the legs are straight up and down. For best results, use a level to
check plumb.
Using the lip mounts and bed mounts as templates, mark holes to be drilled.
Check for access underneath marked holes for clearance needed to install washers and nuts. Adjust position if needed. If access is not
available, use the 3/8” x 1” lag bolts. If using the lag bolts, install by drilling ¼” diameter holes.
Use a drill and make (2) 3/8” diameter holes in the lip of the truck bed and (2) holes in the floor of bed at the marked locations. Repeat for
other rack assembly.
Mount the lip mount to the lip of the truck bed using 3/8”-16 x1-1/4” hex bolts, 3/8” split lock washers and 3/8”-16 nuts.
Mount the bed mount to the bed floor using 3/8”-16 x1-1/4” hex bolts, 3/8” split lock washers and 3/8”-16 nuts.
Check straightness and then tighten all mounting and rack hardware. Position the adjustable center load secure posts as needed.