S2 at escape character (user-defined), S4 response formatting character (user-defined), User-defined) – Toshiba V.92 User Manual
Page 83: S4 response formatting character
83
S-Registers
S-Register values
5.375 x 8.375 ver 2.4.0
S2 AT escape character (user-defined)
This register determines the ASCII value used for an escape
sequence. The default is the + character. The escape sequence
allows the modem to exit data mode and enter command
mode when online. Values greater than 127 disable the escape
sequence.
S3 Command line termination character (user-defined)
This register determines the ASCII values as the carriage
return character. This character is used to end command lines
and result codes.
S4 Response formatting character (user-defined)
This register determines the ASCII value used as the line feed
character. The modem uses a line feed character in command
mode when it responds to the computer.
Range:
0-255
Default:
43
Units:
ASCII
Range:
0-127, ASCII decimal
Default:
13 (carriage return)
Units:
ASCII
Range:
0-127, ASCII decimal
Default:
10 (line feed)
Units:
ASCII