Toshiba V.92 - Manual (Page 76)

76 AT Commands
AT command formats
5.375 x 8.375 ver 2.4.0
Example: +MS=V92,1,0,0
This sets the modulation to be V.92 and the speed
negotiations to use automode. This is the modem default.
Example: +MS=V90,0,0,45333
This will limit the maximum speed to 45,333 bps in V.90
mode.
+MS?
This command displays the current +MS command
configuration.
+MS=?
This command displays all supported values for each +MS
command parameter.
The maximum receive rate. If set to 0,
then the max rate will be determined by
the modulation means selected in the
and settings. Zero
is the default. Valid values
are from 300 to 57333. Maximum receive
rates for each valid are as
follows, in bits per second:
V92 28000—57333 / steps of 1333
V90 28000—57333 / steps of 1333
V34 2400—33600 / steps of 2400
V32B 4800—19200 / steps of 2400
V32 4800—14400 / steps of 2400
V22bis 2400
V22 2200
Bell212A 1200
V23C
1200
V.21 300
Bell103 300