Toshiba V.92 - Manual (Page 62)

62 AT Commands
AT command formats
5.375 x 8.375 ver 2.4.0
P Select pulse dialing
This command configures the modem for pulse (non-touch-
tone) dialing. Dialed digits are pulsed until a T command or
dial modifier is received. Tone dial is the default setting.
Qn Result code control
Result codes are informational messages sent from the
modem and displayed on your monitor. Basic result codes are
OK, CONNECT, RING, NO CARRIER, and ERROR. The
ATQ command allows the user to turn result codes on or off.
Result Codes:
T Select tone dialing
This command instructs the modem to send DTMF tones
while dialing. Dialed digits are tone dialed until a P command
or dial modifier is received. This is the default setting.
Vn DCE response format
This command controls whether result codes (including call
progress and negotiation progress messages) are displayed as
words or their numeric equivalents.
Q0 Enables modem to send result codes to the
computer (default).
Q1 Disables modem from sending result codes to
the computer.
OK n=0,1
ERROR Otherwise
V0 Displays result codes as digits.
V1 Displays result codes as text (default).