Toshiba V.92 - Manual (Page 69)

69 AT Commands
AT command formats
5.375 x 8.375 ver 2.4.0
&V View active configuration and stored profile
The modem maintains two stored profiles, in addition to the
active profile. This command is used to display all three
modem configurations, and any stored telephone numbers.
&W Store current configuration
This command saves the current (active) configuration
(profile), including all S-Registers except S3, S4 and S5.
The current configuration comprises a list of storable
parameters, which you can view using the &V command.
These settings are restored to the active configuration upon
receiving a Zn command or at power-up. Refer to
“&V View
active configuration and stored profile” on page 69 .
Result Codes:
&Y Select stored profile for hardware reset
This command does not change the modem behavior, but is
included for compatibility with applications that issue the
&Y command.
Result Codes:
&V View all three configurations and any stored
telephone numbers.
&W0 Stores the current configuration as profile 0.
&W1 Stores the current configuration as profile 1.
OK n = 0,1.
ERROR Otherwise
OK n = 0,1.
ERROR Otherwise