General Tools and Instruments DCS660 - Manual (Page 8)

SETUP INSTRUCTIONS
INSTALL BATTERIES
The Seeker660’s battery compartment is accessible from the bottom of the pistol grip
(Fig.1, Callout 8).
To open the battery compartment,
1. Use a Phillips-head screwdriver to turn the screw securing the compartment’s cover
counterclockwise until the head of the screw pops up, flush with the surface. It is not
necessary to remove the screw.
2. Turn the cover slightly counterclockwise (about 2°) to release it from the grip
(see figure below). Set the cover (still holding the screw) aside.
3. Extract the yellow battery magazine from the grip by pulling on the tab at its end
(see left figure below).
4. Load four “AA” batteries into the magazine, using the polarity markings within it as a
guide (see right figure below).
5. Push the loaded magazine back into the grip (it fits only one way).
6. Retrieve the battery compartment cover and position it 2° left of center, relative to the
bottom of the grip.
7. Pressing on the cover, twist it 2° clockwise until it “catches” the grip housing.
8. Turn the Phillips-head screw clockwise until it is tight, with its head below the surface.
8