Fairbanks Aegis Industrial Stainless - Manual (Page 5)

A. General Service Policy:
Prior to installation, it must be verified that the equipment will satisfy the customer's
requirements as supplied, and as described in this manual. If the equipment cannot
satisfy the application, and the application cannot be modified to meet the design
parameters of the equipment, the installation should not be attempted.
It is the customer / operator’s responsibility to ensure the equipment provided by
Fairbanks is operated within the parameters of the equipment's specifications and
protected from accidental or malicious damage. Other than the procedures authorized
in the Operating manual, no service, repair, or adjustments may be performed by
unauthorized / untrained service personnel. Any unauthorized repairs will void any
verbal, implied, or written warranties.
B. Overview:
1. These instructions apply to the floor scale and its specific installation procedures.
The instructions include a pre-installation checkout, which must be performed either
at the service center before the technician goes to the site, or at the site before he
places the equipment in service.
2. All electronic and mechanical calibrations and / or adjustments required to make this
equipment perform to accuracy and operational specifications are considered to be
part of the installation, and are included in the installation charge. Only those
charges which are incurred as a result of the equipment's inability to be adjusted or
calibrated to performance specifications may be charged to warranty.
3. Absolutely no physical or electrical modifications other than selection of standard
options and accessories are to be made to this equipment. Electrical connections
other than those specified may not be performed, and physical alterations (holes,
etc.) are not allowed.
4. Before the installation is considered complete, the equipment is to be installed to
satisfy any applicable Weights and Measures requirements. The installing
technician is responsible to make certain that personnel are fully trained and
familiar with the capabilities and limitations of the equipment. Be prepared to
recommend the arrangement of components which will provide the most efficient
layout, utilizing the equipment to the best possible advantage. The warranty policy
must be explained and reviewed with the customer.
51103 5 01/07 -- Rev. 1
Section 2: Installation