Astro Pneumatic 23 Gauge Air Pin Nailer 68022 - Manual (Page 12)

Page 12 For technical questions, please call 1‑800‑444‑3353. SKU 68022
2. Insert the fasteners into the Magazine.
NOTE: Make sure the fasteners are
loaded into Magazine slot head first.
See Figure 2, below.
3. Close and latch the Magazine Cover.
4. When ready, turn the Safety Lock (26) to
the side and press down on the Trigger
to operate.
5. WARNING! There is no contact safety
for the Trigger. When the Safety Lock
(26) is disengaged and the Trigger is
pressed, the Nailer will fire.
6. Test before first use by driving nails
into a sample piece of wood. If the
tool requires more force to accomplish
the task, verify that the tool receives
sufficient, unobstructed airflow (CFM)
and increase the pressure (PSI) output
of the regulator up to the maximum air
pressure rating of this tool.
CAUTION! TO PREVENT TOOL AND
ACCESSORY FAILURE, RESULTING
IN INJURY: Do not exceed the tool’s
maximum air pressure rating.
If the tool still does not have sufficient
force at maximum pressure and
sufficient airflow, then a larger tool may
be required
7. Always make sure the Drive Guide (31)
is flush against the workpiece during
use. Always release the Trigger once the
fastener is driven into the workpiece.
8. After use, to prevent accidents:
a. Release the Trigger and set the
Trigger’s Safety Lock.
b. Detach the air supply.
c. Attempt to fire the Tool into a piece
of scrap wood to ensure that it is
disconnected and is incapable of
firing any fasteners.
d. Clean external surfaces with clean,
dry cloth.
e. Store indoors out of children’s reach.
Figure 2
Fasteners