E-Mon E-MM-RTU-D-N - Manual (Page 55)

Chapter 4 Power Software Configuration tool Administration
Multi-Mon Multiple Circuit Energy Monitor 55
Administration Administration Administration Administration
Power Software allows you to remotely change the password or network
security in your Multi-Mon. Use the device base address to access your
device.
To change the password, select a device site from the list box on the Power
Software toolbar, check the On-line button, click Administration from the
monitor menu, and then select Change Password.
To change the password, type in a new 8-digit password, repeat the
password in the Confirm box, and then click Send.
Upgrading Device Firmware Upgrading Device Firmware Upgrading Device Firmware Upgrading Device Firmware
Your meter has upgradeable firmware. If you need to upgrade your device,
you can download a new firmware file to the meter through Power Software.
Firmware can be downloaded through any communication port. The meter
can be connected to your PC through a serial interface, a dial-up modem, the
Internet, or the RF modem.
Upgrading is only supported through the Modbus RTU and Modbus/TCP
protocols, so your serial port or a dial-up modem port should be put into
Modbus RTU mode.