E-Mon E-MM-RTU-D-N - Manual (Page 23)

Chapter 3 Multi-Mon Display Operations Startup Diagnostics
Multi-Mon Multiple Circuit Energy Monitor 23
Chapter Chapter Chapter Chapter 3 3 3 3 Multi Multi Multi Multi----Mon Mon Mon Mon Display Operations Display Operations Display Operations Display Operations
Startup Diagnostics Startup Diagnostics Startup Diagnostics Startup Diagnostics
After applying power to the meter, a start-up diagnostic message is
displayed for one second. “Power Up” indicates a normal power-up
sequence. You can observe the list of device diagnostic codes recorded
during restart and device operation via the
Status Display .
See Device Diagnostic Codes in Appendix F for the list of diagnostic
messages.
Display Features Display Features Display Features Display Features
The multifunctional 2x16 alphanumeric LCD display with backlight allows
easy read outs of the measurement parameters both in the dark and under
sunlight. The menu-driven multi-page display allows viewing numerous
measurement parameters by scrolling through display screens and pages.
Submeter Displays Submeter Displays Submeter Displays Submeter Displays
In display mode, the display shows readings for the currently selected
submeter. Its number is indicated at the upper-left corner of the display. To
scroll through active submeters, press and hold the SELECT button, and
then use the UP/DOWN buttons to move to another submeter.
Display Update Display Update Display Update Display Update
The display is updated by default once per second; you can adjust the
display update rate via the Display Setup Menu.
Auto Return Auto Return Auto Return Auto Return
If no buttons are pressed for 5 minutes and the display Auto Return option is
not disabled, the display will automatically return to the real-time screen
mode from any other measurement display or programming mode. The Auto
Return option can be disabled through the Display Setup Menu.
Auto Scroll Auto Scroll Auto Scroll Auto Scroll
If no buttons are pressed for 30 seconds while the display is in the real-time
screen mode, and the Auto Scroll option is enabled in the Multi-Mon, the
measurement display will scroll automatically through all submeters. The
scroll interval can be adjusted through the Display Setup Menu. To stop auto
scrolling, press any button.
Backlight Backlight Backlight Backlight
If no buttons are pressed for 1 minute, the Multi-Mon turns the backlight off.
To restore the backlight, press any button briefly.
Navigation Buttons Navigation Buttons Navigation Buttons Navigation Buttons
The Multi-Mon has four push buttons that are normally used to navigate
between screen modes and pages. In programming mode, the buttons allow
you to navigate through device setup menus and to change the device
settings.
The SELECT button functionality:
• In display mode