E-Mon E-MM-RTU-D-N - Manual (Page 41)

Chapter 4 Power Software Configuration tool Changing Port Settings
Multi-Mon Multiple Circuit Energy Monitor 41
NOTE NOTE NOTE NOTE
When using the ExpertPower When using the ExpertPower When using the ExpertPower When using the ExpertPower    client (see client (see client (see client (see Configuring eXpertPo Configuring eXpertPo Configuring eXpertPo Configuring eXpertPower Client wer Client wer Client wer Client ), ), ), ),
submeter address 99 on the Ethernet port COM2 is reserved for the submeter address 99 on the Ethernet port COM2 is reserved for the submeter address 99 on the Ethernet port COM2 is reserved for the submeter address 99 on the Ethernet port COM2 is reserved for the Multi Multi Multi Multi----
Mon Mon Mon Mon router and must not fall inside the range of the submeter addresses for router and must not fall inside the range of the submeter addresses for router and must not fall inside the range of the submeter addresses for router and must not fall inside the range of the submeter addresses for
this port. this port. this port. this port.
Setting Up the Local Network Setting Up the Local Network Setting Up the Local Network Setting Up the Local Network
To enter the setup dialog, select the device site from the list box on the
Power Software toolbar, select Communications Setup from the Meter Setup
menu, and then click the Network Setup tab.
To change the Ethernet settings in your device, select desired parameters,
and then click Send. For the available options, see
Local Network Settings in
Chapter 3.
Configuring eXpertPower Client Configuring eXpertPower Client Configuring eXpertPower Client Configuring eXpertPower Client
The Multi-Mon has an embedded eXpertPower
TM
client that provides
communications with the eXpertPower
TM
server – Cloud AMR services.
Connections to the eXpertPower
TM
server are handled on a periodic basis.
To enter the Setup dialog, select the site from the list box on the Power
Software toolbar, select Communication Setup from the Meter Setup menu,
and then click the ExpertPower Client Setup tab.
The following table lists available options. Refer to your eXpertPower service
provider for the correct eXpertPower settings.
Parameter Parameter Parameter Parameter Options Options Options Options Default Default Default Default Description Description Description Description
XPW Server IP Address 207.232.60.
18 The IP address of the
eXpertPower server
XPW Server Port 0-65535 5001 The TCP service port of the
eXpertPower server