E-Mon E-MM-RTU-D-N - Manual (Page 40)

Chapter 4 Power Software Configuration tool Changing Port Settings
40 Multi-Mon Multiple Circuit Energy Monitor
Enter the password and click OK. If your authorization was successful, you
are not prompted for the password again until you close the dialog window.
Changing Port Settings Changing Port Settings Changing Port Settings Changing Port Settings
This section describes how to configure communication ports in the Multi-
Mon through Power Software.
The communication settings affect all submeters in your device.
Setting Up Communication Ports Setting Up Communication Ports Setting Up Communication Ports Setting Up Communication Ports
To enter the setup dialog, select the site from the list box on the Power
Software toolbar, select Communications Setup from the Meter Setup menu,
and then click on the Serial Ports Setup tab. In the Port box, select the
desired device port.
To change the port settings, select desired port parameters, and then click
Send. For the available communication options, see
Communication Ports in
Chapter 3.