Electronics International MVP-50T - Manual (Page 49)

The “Reading” column at the far right of the screen shows the current reading for each EDC Input. This can be
used to troubleshooting a channel (e.g., you can heat a temperature probe or apply pressure to a pressure
transducer and see which EDC Input responds).
If a probe listed in the “Probe” column is shown in yellow, the calibration of the EDC Input for that probe has been
changed from factory default. EDC Input calibration can only be changed in screen #5. Changing the calibration
for an EDC Input is for advanced users and normally is not recommended.
The EDC fuel level, pressure and temperature inputs can be configured for many different functions using standard
and/or custom probes. To calibrate an EDC Input to a custom probe, see the “5. EDC Input Calibration Screen”
section in this manual.
6.16 “2. Function to Main Screen Mapping” Screen:
This screen allows you to customize the Main Engine Screen by
mapping functions into any of the four arc gauges, six vertical
gauges or six digital gauges.
49
6.17 “3. Function to System Screen Mapping” Screen:
This screen allows you to customize the System Screen by
mapping a Function into any one of the seven Digital gauges on the
left side of this screen or any one of the four Horizontal Strip
gauges located on the right side of this screen.
Also, annunciators may be mapped into the right portion of this
screen. The annunciators mapped into the left column (top to
bottom) of this screen will show in the top row (left to right) on the
Main Engine Screen. The annunciators mapped into the right
column (top to bottom) of this screen will show in the second row
(left to right) on the Main Engine Screen.
Note: Trim and Flaps are automatically mapped to the appropriate
screen locations.