Electronics International MVP-50P - Manual (Page 7)

Contents
(Page 1 of 3)
Warranty/Agreement-------------------------------------------------------------------------------------- 1A
1.0 System Overview ------------------------------------------------------------------------------------- 2
1.1 MVP Description ------------------------------------------------------------------------------ 4
1.1.1 MVP Display ---------------------------------------------------------------------------- 4
1.1.2 EDC-33P --------------------------------------------------------------------------------- 4
1.1.3 Probes, Transducers and Modules --------------------------------------------------- 5
1.1.4 Wiring & Extension Cables ----------------------------------------------------------- 5
1.2 Operational Overview ------------------------------------------------------------------------------- 5
1.3 Installation Overview --------------------------------------------------------------------------------- 5
1.4 Password Protection ---------------------------------------------------------------------------------- 6
1.4.1 Level #1 Password (Maintenance) ------------------------------------------------------- 6
1.4.2 Level #2 Password (OEM) ---------------------------------------------------------------- 7
2.0 Hardware Installation -------------------------------------------------------------------------------- 9
2.1 Important Information and Initial Check Out: ------------------------------------------- 11
2.2 Review the "EDC Wiring Work Sheet:" -------------------------------------------------- 12
2.3 Verify you have all the necessary Probes, Modules, Transducers and Cables: ----- 12
2.4 Install the MVP Display: --------------------------------------------------------------------- 12
2.5 Install the Post Lights: ------------------------------------------------------------------------ 13
2.6 Install the Temperature Probes: ------------------------------------------------------------- 13
2.7 Install the Pressure Transducers: ----------------------------------------------------------- 15
2.8 Install the Interface Circuit for Annunciators -------------------------------------------- 19
2.9 Install the Interface Circuit for Flaps and Trim ------------------------------------------ 20
2.10 Install the Interface Circuit for the Gear Position, Unsafe Indicator and Gear --- 20
2.11 Install the CO-Guardian CO Detector -------------------------------------------------- 21
2.12 Install the Shunt: ----------------------------------------------------------------------------- 21
2.13 Install the Fuel Flow Transducer: --------------------------------------------------------- 24
2.14 Install the P-300C Fuel Level Probes (OEM or Experimental) --------------------- 30
2.15 Install the P-300M Fuel Levl Sender: ---------------------------------------------------- 30
2.16 Install the Resistive Fuel Level Module (RFLM-4-X): ------------------------------- 31
2.17 Install the Voice Alarm Control Panel (OEM or Experimental): ------------------- 31
2.18 Install the Intensity Control Pot (Optional): -------------------------------------------- 31
2.19 Install the Master Warning (red) and Caution (yellow) Lights: ----------------------- 32
2.20 Install the EDC-33P: ------------------------------------------------------------------------ 32
3.0 Install the EDC Wire Harnesses and Route Wires ---------------------------------------------- 33
3.1 Attach the three EDC 37-pin wire harnesses to the EDC: ---------------------------- 35
3.2 Connect the EDC Harness to the Temperature Probes: -------------------------------- 35
3.3 Connect the EDC Harness to the Pressure Transdcueres: ----------------------------- 35
3.4 Connect the EDC Harness to the Shunt: -------------------------------------------------- 36