Electronics International MVP-50P - Manual (Page 49)

43
4.5 Connect the MVP Harness to the Audio Panel:
If the voice alarms provided by the MVP are to be used, route the two MVP Voice Warning Out wires to the
Audio Panel, cut the wires to length and connect to the Audio Panel Aux input and ground. If an audio input is
not available on the Audio Panel (or an Audio Panel is not installed) you can connect the MVP Voice Warning
Out wires to the pilot headset jack. With this installation a 49.9 ohm 1/4 watt resistor will need to be installed
in series with the MVP +Voice Warning Out wire and the audio feed wire to the jack.
4.6 Connect the MVP Harness to the External Intensity Control Pot (CP-1):
If the MVP display intensity is to be controlled
externally, route the MVP Back Light Control
In wire (orange) to the CP-1, cut the wires to
length, install the appropriate connectors (see
the “Working with Connectors” section of this
manual for more information) and connect to
the CP-1. Install the ground and power wires
to the CP-1 as shown in the paperwork sup-
plied with the control pot.
4.7 Connect the MVP Harness to the Moving Map Data Out from the GPS:
If the MVP is to provide fuel data to the current way point, route the MVP "Moving Map Data In" wire (green
wire in a 4 wire cable) to the Moving Map Data Output Port on the GPS. Cut the wire to length, install the
appropriate connector and connect to the GPS port.
4.8 Connect the MVP Harness to the Fuel Data Input on the GPS:
If the GPS is capable of displaying fuel data and this feature is to be used, route the MVP "Fuel Data Out" wire
(white wire in a 4-wire cable) to the Fuel Data Input Port on the GPS. Cut the wire to length, install the appro-
priate connector and connect to the GPS port.
Moving Map Data In (Grn, Pin 8)
Fuel Flow Data Out (Wht, Pin 7)
Wire Cable
GPS
MVP
GPS Input &
Output
+Voice
(Wht/Blue, Pin 23)
-Voice
(Wht/Gray, Pin 24)
Audio Feed (from Radios)
Pilot's Audio Jack
49.9 Ohms
MVP
Voice Output
Gnd
To Gnd (Blk)
To 12V (Wht)
or
To 24V (Wht)
MVP
Back Light Cntrl
Input
(Wht/Org, Pin 25)
Wht/Brn
Wht/Red
Blk
Wht/Org