Electronics International MVP-50P User Manual

Page 26

E. Airspeed Transducer Installation:

Airspeed Transducer Installation:

Mount the PT-05Diff Pressure Transducer
on the inside firewall or in the equipment
bay under the aircraft instrument panel.
Use the holes in the bottom plate to mount
the PT-05Diff. Only two mounting holes
are required.

Connect the aircraft pitot
(airspeed) line to the port
tagged "Press" on the PT-
05Diff. Connect the
aircraft static pressure line
to the port tagged "Vac" on
the PT-05Diff. Be sure these lines are tight. The ports are 1/4" flare union. Care should be taken not to put
excess pressure on the flexible lines. Make sure the flexible lines do not kink.

F. Altitude Transducer Installation:

Altitude Transducer Installation:

Mount the PT-30Alt Altitude
Transducer on the inside
firewall or in the equipment
bay under the aircraft instru-
ment panel. Use the holes in
the bottom plate to mount the
PT-30Alt. Only two mounting
holes are required.

Connect the
aircraft static
line to the port
on the PT-
30Alt. Be sure
this line is tight.
The port is a 1/
4" flare union. Care should be taken not to put excess pressure on the flexible line. Make sure the flex-
ible line does not kink.

G. Other Pressure Transducer Installations:

Other Pressure Transducer Installations:

Other pressure transducers should be mounted in the aircraft in the same manner as the Gyro Vacuum
Transducer or the Oil and Fuel Pressure Transducers, as appropriate. Note: Any unused + or - pres-
sure inputs must be wired to a ground pin on the EDC 37-pin connector.

Open or Over-

Gyro Vacuum
Line

(

Red)

(

Blk)

(

Grn)

(

Wht)

PRESS

VAC

To EDC

Press Input

(Top Connector)

Pitot Line

Static Line

.170" ID Flexible Tube

Aircraft Static Line

(Red)
(Blk)

(Grn)

(Wht)

To EDC

Press Input

(Top Connector)