Electronics International MVP-50P User Manual

Page 18

2.0

Hardware Installation

2.1 Important Information and Initial Checkout:

2.2 Review the "EDC Wiring Work Sheets:"

2.3 Verify You Have all the Probes, Modules, Transducers and Cables:

2.4 Install the MVP Display:

2.5 Install Post Lights

2.6 Install the Temperature Probes:

2.7 Install the Pressure Transducers:

2.8 Install the Interface Circuit for Annunciators:

2.9 Install the Interface Circuit for Flap and Trim Pots (OEM / Experimental):

2.10 Install the Interface Circuit for the Gear Position, Unsafe Indicator and Gear

Warning:

2.11 Install the CO Detector, G-Sensor and/or Other Available MVP Options:

2.12 Install the Shunt:

2.13 Install the Fuel Flow Transducer:

2.14 Install the EI P-300C Fuel Level Probes (OEM or Experimental Only):

2.15 Install the EI P-300M Fuel Level Sender:

2.16 Install the Resistive Fuel Level Module (RFLM-4-X):

2.17 Install the Voice Alarm Control Panel (OEM or Experimental Only):

2.18 Install the Intensity Control Pot (Optional):

2.19 Install the Master Warning (red) and Caution (yellow) Lights:

2.20 Installing the EDC-33P: