Teledyne BDS-3960 - Oxygen analyzer - Manual (Page 7)

Oxygen Analyzer
Teledyne Analytical Instruments vii
3.2 Mounting the Analyzer 30
3.3 Rear Panel Connections 32
3.3.1 Gas Connections 32
3.3.2 Electrical Connections 33
3.3.2.1 Primary Input Power 34
3.3.2.2 50-Pin Equipment Interface Connector 34
3.4 Electrolyte Refill of BDS Sensor 39
3.5 Testing the System 40
3.6 Powering Up the System 41
Operation ..................................................................................... 42
4.1 Introduction 42
4.2 The Analyzer application 43
4.3 The System Screen 44
4.3.1 Communication Information and Calibration Parameters 44
4.3.2 Setting Software Parameters: Filter, Gas Factor,
Tmp. Coeff. 45
4.3.2.1 The Digital Filter 46
4.3.2.2 The Gas Factor 46
4.3.2.3 Temperature Coefficient 47
4.3.2.4 Set Defaults 48
4.4 Calibration of the Analyzer 49
4.4.1 Zero Cal 49
4.4.1.1 Zero Failure 50
4.4.2 Span Cal 50
4.4.2.1 Span Failure 51
4.5 The Alarms Function 51
4.6 The Range Function 53
4.6.1 Setting the Analog Output Ranges 53
4.6.2 Fixed Range Analysis 55
4.8 Signal Output 55