Teledyne 4030 - Total Hydrocarbon gas analyzer - Manual (Page 44)

Operation
Teledyne Analytical Instruments 42
Note however, that the instrument can still be used for analysis
without entering the password. To defeat security the password must be
entered.
Note: If you use password security, it is strongly advised to keep
a copy of the password in a separate, safe location. If the
password is lost and security is enabled, the analyzer must
be cold-booted. Cold booting invalidates parameters
necessary for correct operation so they must be re-
entered.
ENTERING A PASSWORD
To install a new password or change a previously installed password,
you must key in and ENTER the old password first. If the default
password is in effect it will be displayed as the default gausses for each
letter, pressing for each letter of the password will enter the
default password for you.
To enter a password:
<any key> From the ANALYSIS SCREEN Enter MAIN MENU
setup by pressing an ARROW KEY.
<▲▼> Use the UP or DOWN key to scroll to PASSWORD.
________________________________________________
AUTOCAL
-> PASSWORD
________________________________________________
<Enter>
Press to activate the password function. Either
the default TAI password or AAA place holders for an
existing password will appear on screen.
ENTER PASSWORD SCREEN
________________________________________________
Enter a Password
'T' 'A' 'I'
________________________________________________
<▲▼> Use
the ▲▼ keys to change the letters to the proper
password.
<Enter> Press to advance to the next letter