PROLiNK PHC105 User Manual - Manual (Page 8)

PROLiNK® PHC-105 User’s Manual www.prolink2u.com
Version 1.00 3 English
CHAPTER 2 INSTALLATION
2.1 Install the SIM/USIM Card
 Remove the rubber cover from the left side of the camera.
 Open the SIM/USIM card slot by pressing the small dot beside the card slot with the tip of a pencil, and pop
open the slot.
 Insert the card into the slot.
 Push the slot back into place.
 Put the rubber cover back in its place.
2.2 Extending The Camera’s Base Board
 Hold the base of the camera and pull the top part and the bottom part (base) in opposite directions (i.e. away
from each other).
 Then the slot buckle will be pulling open.
 The head of the camera can now be moved freely and located at any direction.
2.3 Connecting To Power Adapter
 Connect the adapter to an AC power, and connect the mini-USB plug to the power interface of the
camera .(See Figure 1)
 The camera has a built-in rechargeable Lithium battery.
 The camera will notify the user when the power changes. For example, if the power adapter is disconnected or
failure of the AC power occurs, the camera will notify the user “External power cut. The device is operating on
battery.”
 If the camera is again connected to the external power, or the AC power is available again, the notification will
be sent to the user, i.e.” The device is now resuming the use of external power source.”
 Low battery: The configure setting cannot be saved when the camera is operating on low battery.
2.4 Mount the Camera
The camera can be mounted on a wall (vertically with the screws) or put down on any suitable horizontal surface.
2.5 Choose the Installing Place
 In order to capture better image quality, avoid any areas where bright light will be irradiated directly into the
lens of the camera on the camera.
 In order to avoid backlighting photography, it is suggested that the camera is located at the place where can
look down the monitoring place with the minimum angel 30°.
 The GSM/WCDMA network’s signal strength may affect the image, live voice, video quality and MMS
transmission speed. Therefore, upon installation, the user should ensure that the camera is located in an area
with a strong network signal.