PROLiNK PHC105 User Manual - Manual (Page 20)

PROLiNK® PHC-105 User’s Manual www.prolink2u.com
Version 1.00 15 English
CHAPTER 5 ADVANCED SETTINGS
5.1 Alarm Settings
The camera will enter auto-alarm mode and send notification messages to the previously set alarm number or E-mail
addresses once the built-in sensor is detected. Any mobile phone can send following commands to the camera to set
alarm ways.
5.1.1 SMS Command [21 & 22] - Warning with tone or without tone upon alarm triggered
User must send the following SMS Command to device via mobile phone.
PSWD BEEP ON
PSWD BEEP OFF
 PSWD is a four digit number password. The original password is 1234.
 For example：1234 BEEP ON
 With warning tone is configured as default.
 After successful set, the camera will sound “Di…” tone when alarming. If warning tone and phone call are
set at the same time, warning tone will close once the phone goes through.
 The camera will not emit “Beep …” tone upon alarm activation.
5.1.2 SMS Command [23 & 24] – Send or not to send SMS notification upon alarm triggered
User must send the following SMS Command to device via mobile phone.
PSWD SEND SMS OFF
PSWD SEND SMS ON
 PSWD is a four digit number password. The original password is 1234.
 For example：1234 SEND SMS OFF
 Send SMS is configured as default.
5.1.3 SMS Command [25 & 26] – Send MMS or not to send MMS notification upon alarm triggered
User must send the following SMS Command to device via mobile phone.
PSWD SEND MMS OFF
PSWD SEND MMS ON
 PSWD is a four digit number password. The original password is 1234.
 For example：1234 SEND MMS OFF
 Send MMS is configured as default.