Bosch Kompakt-Dampfgenerator Sensixx´x DI90 AntiShine TDI903231A anthrazit metallic rosso rot - Manual (Page 19)

17
BOSCH
* Model dependent
EN
gl
ISH
Temperature Suitable for
● synthetics
●● silk – wool
●●● cotton
max linen
i-Temp Advanced* any type of fabric which
can be ironed
AntiShine*
dark and delicate fabrics.
Reduces the risk of shiny
marks
☞ ☞ Tips for ironing: If you start ironing at a
high temperature and then select a lower
one, the soleplate may take a while to cool
down. To speed up the cooling process,
you may press the shot of steam button (7)
or press the steam activation button (2*).
3.1 “Tempok” indicator
While the soleplate is heating up or cooling down
to the selected temperature, the “TempOK” lights
inside the temperature control (15) will flash.
When the selected temperature is reached, the
lights will stop flashing and remain lit
continuously.
3.2 “i-Temp advanced” function *
If this function is selected, an appropriate
combination of temperature and steam is set
which is suitable for all fabrics that can be ironed.
The “i-Temp Advanced” function prevents clothes
from becoming damaged due to an unsuitable
temperature being selected.
The “i-Temp advanced” function does not
apply to fabrics that cannot be ironed. Please
check the garment care label for details or try
ironing on a part of the fabric not visible normally.
When the “i-Temp Advanced” function is selected,
the blue light inside the temperature control
comes on.
3.3 “antiShine” function *
If this function is selected, the risk of shiny marks
on the garment due to the ironing is reduced.
When the “AntiShine” function is selected, the blue
light inside the temperature control comes on.
4. Setting the steam amount

See the leaflet sides
The steam control is used to adjust the
amount of steam produced when ironing.
Your iron is equipped with a steam setting
selection button (4) and with indicator lamps (5)
showing the steam setting, according to the table
below:
Steam
setting
eco max
steam
off
Indicator
lamps SET
Green
SET
Red
SET
Off
The steam setting can be changed by pressing
the steam setting selection button (4).
☞ ☞ Tips for ironing: For better ironing results,
iron the last strokes without steam to dry
the garment.
5. Ironing with steam

See the leaflet sides
Steam can be generated by gripping the handle
(1), or by pressing the steam activation button
(2*).
5.1 Continuous steam generation
1. Set the steam control to “eco” or “max”
position.
2. Grip the handle (1).
5.2 Steam on demand *
1. Set the steam control to the position, to
cancel continuous steam generation while
gripping the handle (1).
2. Press the steam activation button (2*).
While the pump is working, the lights (17) at rear
of the water tank go on.